Vulcan 330M Manual do Utilizador

BK46716 (03-11)MANUAL FLYWHEEL SLICING MACHINE Instruction for use, installation and maintenance Model 330M

9Installation, use and maintenance 330M9 4.2 MAIN COMPONENTS 1. Food plate 2. Slice deflector 3. Sliding overplate 4. Carriage 5. Flywheel manouevrin

104.3 GENERAL DESCRIPTION The slicing machine has been designed and made to offer maximum safety when in use, during cleaning and ordinary maintenance

11Installation, use and maintenance 330M11 5. INSTALLATION 5.1 INSTALLATION OF THE MACHINE If a support column is not used, install the machine on a

12Installation, use and maintenance 330M12 6. USING THE SLICING MACHINE 6.1 LOADING THE GOODS - Using the flywheel (1) bring the carriage (2) all for

13Installation, use and maintenance 330M13 6.3 CLEANING THE SLICING MACHINE6.3.1 GENERAL INFORMATION The machines must be properly cleaned at least o

14Installation, use and maintenance 330M14 7. MAINTENANCE AND REPAIRS 7.1 GENERAL INFORMATION The operator is allowed to carry out the following main

15Installation, use and maintenance 330M15 7.2 SHARPENING THE BLADE Proceed as follows as soon as it is noticed that there is less cutting capacity:

16Installation, use and maintenance 330M16 7.3 LUBRICATING THE GUIDE BARS OF THE CARRIAGE AND OVERPLATE - After each cleaning operation of the machin

17Installation, use and maintenance 330M17 7.5 ADJUSTING THE BEVEL GEAR PAIRIf there is too much play in the flywheel at the start of rotation procee

Installation, use and maintenance 330M1 LIST OF CONTENTS Page 1. INTRODUCTION ...

BK46716 (03-11)

Installation, use and maintenance 330M2 1. INTRODUCTION 1.1 PURPOSE OF THE MANUAL This publication contains all the information necessary for the ins

Installation, use and maintenance 330M3 - Install the machine according to the instructions in the paragraph “Installation”; - Install the machine so

4Installation, use and maintenance 330M4 2.3 USER’S OBLIGATIONSThe user must scrupulously observe the instructions in this manual for the manufacture

5Installation, use and maintenance 330M5 3. TECHNICAL CHARACTERISTICS 3.1 MAIN TECHNICAL DATA Rif. Detail mm A Feet distance 630 B Distance begin

6Installation, use and maintenance 330M6 3.2 PRODUCTS THAT CAN BE SLICED The following are products that can be sliced: - All types of cold cuts (coo

7Installation, use and maintenance 330M7 Supply of machine only: - Lift the machine carefully and insert the four similar rubber feet in the lodgings

8Installation, use and maintenance 330M8 Assembly of the flywheel: Move the machine carriage all the way towards the operator.Take out the taper pin